WACO 10
Waco data will be added later when time permits
Preparing to load at Deland Florida
Everything loaded
Unloading at St. Louis Mo.
A lot of stuff in there
Wings are easy
Still a lot of stuff
OXX-6 engine is next
Not so easy
Fuselage is all that is left
Every small space in the shop gets something
Paint room is full
Engine mount being realigned
Fixed
Realigned and ready to clean and paint
Floorboards being installed
Control assembly installed
Seats installed
Firewall and side stringers fitted
Top framing being replaced
Stringers instaled
Rear bulkhead finished
Baggage compartment finished
New side panels being fabricated
Left side done
Engine mounted to fabricate controls and instrument connections
Waiting for the controls to be fitted
Setting p new instrument panel
Preparing to form the panel
New panel
Fitting cowling
Setting up control linkages
Center section mounted to set up radiator connections
On the way to the shop hangar (next to the last on the right)
View from the hangar door
June 17 2019 Water is 9 3/4 inches deep inside the hangar and electricity is off so nothing can be accomplished until the airport is back to normal and cleaned up